Westfalia OSD 6-91-067 Instruction Manual page 143

Westfalia Separator
Mineraloil Systems GmbH
2058-9001-101 / 0506
Fig. 232
Fig. 233
Fig. 234
Fig. 235
• Insert gasket 1 in the groove in the
lower section of frame.
• Fit rubber-metal cushion 2.
Pay attention to the correct fitting
position of the rubber-metal cush-
ion!
The two opposite inner holes 3 of
the rubber-metal cushion must be
directed upwards.
• Turn spindle through 180
down).
• Mount bearing covers 1 and 2.
Pay attention to the correct fitting
position of the bearing cover!
• Grooved ball bearing 3
o
– Heat in oil to 80 C and
– slide onto the spindle.
• Insert retaining ring 4 in the spindle
groove.
• Ball
bearing protection
grooved ball bearing 2, and angular
contact ball bearing 3 :
o
– Heat in oil to 80 C and
– slide onto the spindle.
Bearing damage is caused by incor-
rect fitting!
• When fitting angular contact ball
bearing 3 on the spindle, make sure
that the narrow rim of the ball bear-
ing inner ring faces upwards to the
spindle end.
• Install the assembled spindle as-
sembly 1 in the lower section of
frame and
• Bolt tight with the three hex head
screws 2.
143
o
(upside
ring 1