142
4.6.5 Fitting the spindle assembly
• Pay special attention to section 4.6.1.
• For dimensions of the parts see 4.6 - exploded view.
Fig. 229
Fig. 230
Fig. 231
Westfalia Separator
Mineraloil Systems GmbH
If necessary:
• Insert retaining ring 1 in the pivoting
bearing groove.
Tool:
commercially available inner snap pli-
ers with offset jaws
If necessary:
• Insert gasket 1 in the groove in the
lower section of frame.
If necessary:
• Bolt tight bearing cover 1 (with hex
head screw
glued in with Loctite
three hex head screws 2.
2058-9001-101 / 0506
) with