Westfalia OSD 6-91-067 Instruction Manual page 120

120
Fig. 175
Fig. 176
Fig. 177
Fig. 178
Westfalia Separator
Mineraloil Systems GmbH
FITTING
• Thoroughly
clean
groove.
• Heat the gasket in approx. 80
water for 5 minutes.
• Gasket
– clean and wipe dry
– lightly press into the groove.
• Pull the polyamide gasket into the
groove applying a vice at four dia-
metrically opposite points.
Then
• pull the gasket bit by bit into the
groove with the vice.
Use smooth copper jaws.
If the dimension of the pressed-in gas-
ket is more than 0.5 mm,
• the polyamide gasket must be fur-
ther pressed in the vice.
• By carrying out several measure-
ments around the entire circumfer-
ence of the annular piston, check
that the polyamide gasket is seated
parallel in the groove.
2058-9001-101 / 0506
and dry the
o
C