Table of Contents
Advertisement
SuperServer 6029TP-HTR/HC0R/HC1R User's Manual
Add-on Card
Riser Card
Figure 3-18. Installing a Low Profile Add-On Card
56
Chapter 3: Maintenance and Component Installation
Power Supply
The 6029TP-HTR/HC0R/HC1R has a high-efficiency single 2000 Watt power supply, which
is auto-switching capable. This enables it to automatically sense and operate with a 100V to
240V input voltage.
Power Supply Replacement
The SC827HQ+ chassis utilizes two redundant power supplies. In the unlikely event that the
power supply unit needs to be replaced, one power supply can be removed, without powering
down the system. Replacement units can be ordered directly from Supermicro (See the
contact information in the Preface of this manual).
Changing the Power Supply (Figure 6-18)
1. Power down all four nodes and unplug the power cord.
2. Push the release tab (on the back of the power supply) as illustrated.
3. Pull the power supply out using the handle provided.
4. Push the new power supply module into the power bay until you hear a click.
5. Plug the AC power cord back into the module and power up the nodes.
Release Tab
Figure 3-19. Removing/Replacing a Power Supply
57
Advertisement
Table of Contents
