Supermicro SuperServer 6029TP-HTR User Manual page 19

SuperServer 6029TP-HTR/HC0R/HC1R User's Manual
Installing the Processor Heatsink Module (PHM)
1. Once you have assembled the processor heatsink module (PHM) by following the
instructions listed on page 29 or page 30, you are ready to install the processor heatsink
module (PHM) into the CPU socket on the motherboard. To install the PHM into the
CPU socket, follow the instructions below.
2. Locate the triangle (pin 1) on the CPU socket, and locate the triangle (pin 1) at the
corner of the PHM that is closest to "1." (If you have difficulty locating pin 1 of the PHM,
turn the PHM upside down. With the LGA-lands side facing up, you will note the hollow
triangle located next to a screw at the corner. Turn the PHM right side up, and you will
see a triangle marked on the processor clip at the same corner of hollow triangle.)
3. Carefully align pin 1 (the triangle) on the the PHM against pin 1 (the triangle) on the
CPU socket.
4. Once they are properly aligned, insert the two diagonal oval holes on the heatsink into
the guiding posts.
5. Using a T30 Torx-bit screwdriver, install four screws into the mounting holes on the
socket to securely attach the PHM onto the motherboard starting with the screw marked
"1" (in the sequence of 1, 2, 3, and 4).
Note: Do not use excessive force when tightening the screws to avoid damaging the LGA-
lands and the processor.
Oval C
Oval D Large Guiding Post
Small Guiding Post
Printed Triangle
Mounting the Processor Heatsink Module
into the CPU socket (on the motherboard)
36
Use a torque
of 12 lbf
T30 Torx Driver
#4
#2
#1
#3
Tighten the screws in the
sequence of 1, 2, 3, 4 (top 3 quarter view)
Chapter 3: Maintenance and Component Installation
Removing the Processor Heatsink Module (PHM) from the Motherboard
Before removing the processor heatsink module (PHM), unplug power cord from the power
outlet.
1. Using a T30 Torx-bit screwdriver, turn the screws on the PHM counterclockwise to
loosen them from the socket, starting with screw marked #4 (in the sequence of 4, 3, 2,
1).
2. After all four screws are removed, wiggle the PHM gently and pull it up to remove it
from the socket.
Note: To properly remove the processor heatsink module, be sure to loosen and remove the
screws on the PHM in the sequence of 4, 3, 2, 1 as shown below.
Removing the screws in
the sequence of 4, 3, 2, 1
#4
#2
#1
#3
Printed Triangle on Motherboard
37
CPU Socket
After removing the screws,
lift the Processor Heatsink
Module off the CPU socket.