Table of Contents
Advertisement
SuperServer 6029TP-HTR/HC0R/HC1R User's Manual
Note: Visit the product page on the Supermicro website for possible updates to memory
support (www.supermicro.com).
DIMM Removal
Reverse the steps above to remove the DIMM modules from the motherboard.
PCI Expansion Card Installation
The system includes a pre-installed riser card (p/n CSE-RR1U-E8) that positions a standard
size PCI-E x8 card at a 90 degree angle, allowing it to fit inside the chassis.
Installing PCI Expansion Cards
The riser card has already been pre-installed into the motherboard. Perform the following
steps to install an add-on card:
Begin by removing power from the system as described in section 3.1.
1. Remove the chassis cover to access the inside of the system.
2. Remove the PCI slot shield on the chassis by releasing the locking tab.
3. Insert the expansion (add-on) card into the riser card.
4. Secure the card with the locking tab.
Motherboard Battery
The motherboard uses non-volatile memory to retain system information when system power
is removed. This memory is powered by a lithium battery residing on the motherboard.
Replacing the Battery
Begin by removing power from the system as described in section 3.1.
1. Push aside the small clamp that covers the edge of the battery. When the battery is
released, lift it out of the holder.
2. To insert a new battery, slide one edge under the lip of the holder with the positive (+)
side facing up. Then push the other side down until the clamp snaps over it.
Note: Handle used batteries carefully. Do not damage the battery in any way; a damaged
battery may release hazardous materials into the environment. Do not discard a used battery
in the garbage or a public landfill. Please comply with the regulations set up by your local
hazardous waste management agency to dispose of your used battery properly.
44
Chapter 3: Maintenance and Component Installation
Figure 3-2. Installing the Onboard Battery
Warning: There is a danger of explosion if the onboard battery is installed upside down (which
reverses its polarities). This battery must be replaced only with the same or an equivalent type
recommended by the manufacturer (CR2032).
45
OR
Advertisement
Table of Contents
