Supermicro SuperServer 6029TP-HTR User Manual page 25

SuperServer 6029TP-HTR/HC0R/HC1R User's Manual
Drive Tray
Figure 3-11. Chassis Drive Tray
1
Figure 3-12. Removing Dummy Drive from Tray
Caution: Except for short periods of time while swapping hard drives, do not operate the server
with the hard drives empty.
48
Dummy Drive
1
Chapter 3: Maintenance and Component Installation
Installing the Hard Drive
1. Install a new drive into the carrier with the printed circuit board side facing down so that
the mounting holes align with those in the carrier.
2. Secure the hard drive by tightening all six (6) screws.
3. Use the open handle to replace the drive tray into the chassis. Make sure the close the
drive tray handle.
Hard Drive
2
Drive Tray
Figure 3-13. Installing the Hard Drive
Note: Enterprise level hard disk drives are recommended for use in Supermicro chassis and
servers. For information on recommended HDDs, visit the Supermicro website at
supermicro.com/products/nfo/files/storage/SBB-HDDCompList.pdf
49
2
http://www.