Table of Contents
Advertisement
Chapter 4
Machine's Boom Function Coils
FIGURE 19.
Locate the machine's boom function coils on the machine's hydraulic valve.
11.
Locate the left tilt up coil.
12.
Determine which wire feeding into the coil receives the signal from the switches in the cab by pressing the
13.
switch and using a test light or multi-meter to detect +12 volts.
Locate the Left Solenoid Sense Up connector on the AutoBoom harness cable (P/N 115-0230-045 or 115-
14.
0230-085).
Use a 16-18 gauge scotch lock parallel splice connector (p/N 405-2001-079) to connect the left tilt up coil
15.
wire to the Left Solenoid Sense Up connector.
Locate the left tilt down coil.
16.
Determine which wire feeding into the coil receives the signal from the switches in the cab by pressing the
17.
switch and using a test light or multi-meter to detect +12 volts.
Locate the Left Solenoid Sense Down connector on the AutoBoom harness cable.
18.
Use a 16-18 gauge scotch lock parallel splice connector (P/N 405-2001-079) to connect the left tilt down coil
19.
wire to the Left Solenoid Sense Down connector.
Repeat the steps above to connect the right tilt up and down coils to the Right Solenoid Sense Up and
20.
Down connectors on the AutoBoom harness cable.
Connect the Harness Cable to the Implement Extension Tee -
Gen II Cable Only
Route the harness cable (P/N 115-0230-085) toward the implement extension tee cable.
1.
Connect the harness cable to the To Node connector.
2.
Remove the terminator from the machine's chassis harness or the standalone console harness.
3.
Install the terminator on the remaining open end of the implement extension tee cable.
4.
Refer to the wiring schematic (beginning on page 44) appropriate for the machine's configuration to route
5.
the implement extension tee cable.
Connect the implement extension tee cable to the location determined in the step above.
6.
Connect the Harness Cable to the Controller Cable - Gen I
Cable Only
Route the harness cable (P/N 115-0230-045) toward the machine's cab.
1.
Connect the harness cable to the controller cable (P/N 115-0230-007).
2.
42
Willmar Eagle 8500 AutoBoom Installation Manual
Advertisement
Table of Contents
