Table B-4. Delete Equipment - ADTRAN H2TU-C Installation And Maintenance Practice

Appendix B, Litespan H2TU-C Provisioning Tutorial - Provisioning the Litespan H2TU-C via TL1 Commands
Function: Deletes the provisioning information for equipment units.
Input format:
DLT-EQPT:<TID>:<AID>:<CTAG>;
Example:
DLT-EQPT::COT-1-ONU1-2;
Menu Access: Main Menu → 3. Provisioning Menu → 4. Equipment Provisioning Menu →
1. DLT-EQPT
Code Definition
<TID> Target ID
<AID> Access ID
<CTAG> Correlation tag
System Response:
/* <number> Equipment Units Deleted */
7. Remove the previous module from the slot, if present.
8. Insert the H2TU-C into the slot. Litespan automatically installs the line card with default
provisioning data stored in the shelf controller.
9. Retrieve the T1s to be cross-connected with the RTRV-T1 command; type
RTRV-T1::<TERMINAL>-<BANK>-<SLOT>&<TERMINAL>-<BANK>-<SLOT>;
(See Table B-3 for details on the RTRV-T1 command.)
An example of this command string is
10. Is the secondary service state (SST) of either T1 UEO-MT?
If yes, go to Step 11.
If no, go to Step 12.
11. Restore the underlying equipment to service with the RST-EQPT command; type
RST-EQPT::<TERMINAL>-<BANK>-<SLOT>;
12. Is the primary service state (PST) of either T1 OOS-MT (out of service for maintenance)?
If yes, go to Step 13.
If no, go to Step 14.
13. Restore the T1 facility to service by typing the following RST-T1 command:
RST-T1::<TERMINAL>-<BANK>-<SLOT>;
14. Is the primary service state (PST) of either T1 OOS-MA (out of service for memory
administration)?
61221002L1-5F

Table B-4. Delete Equipment

Command: DLT-EQPT
Parameter Usage
Description
No user entry needed. Default = connected terminal.
Enter <TERMINAL>-<BANK>-<SLOT> of equipment to be deleted.
Default = ALL.
No user entry needed. Default = 0.
RTRV-T1::COT-2-15&RT-2-10;
B-9