ADTRAN H2TU-C Installation And Maintenance Practice page 44

Litespan H2TU-C Installation and Maintenance Practice
<GOS>
<HAIS>
<LP>
<LPBK-ACTC>
<LPBK-ACTR>
<LPBKDEACTCDE>
<LPBK-TMO>
<LPBKTMODEACT>
<NIDLPBK>
<NTWKKPALV>
<PRGMLPBKC>
B-14
Table B-7. Edit HDSL (Continued)
Command: ED-HDSL
AID of GOS table <Terminal>-GOS<GosNum>. A GOS table cannot be
to be used assigned unless it has already been defined. GOS1 is the
system default.
Default = no change
Half AIS Options: NO, YES. Default = no change.
YES = AIS is transmitted when either HDSL loop detects
LOSW.
NO = AIS is transmitted when both HDSL loops detect
LOSW.
Line Powering Options: SOURCE, SINK. Default = no change.
SOURCE = Enable line powering, current source.
SINK = Disable line powering, current sink.
Loopback 16-bit code used to activate the inband loopback at the
activation code, HTU-C. The leftmost bit is the most significant bit
H2TU-C (MSB).
Default = no change.
Loopback 16-bit code used to activate the inband loopback at the
activation code, HTU-R. The leftmost bit is the most significant bit
H2TU-R (MSB).
Default = no change.
Loopback 16-bit code used to deactivate the inband loopback. The
deactivation code leftmost bit is the most significant bit (MSB).
Default = no change.
Loopback time- 0, 20, 60, or 120 (minutes). An entry of 0 disables time-
out period out.
Default = no change.
Loopback time- 16-bit code used to disable the inband loopback timer.
out deactivation
Default = no change.
code
Network interface Determines if the HTU-R shall respond to loopback
device loopback request codes.
Options: YES, NO.
Network keep- Determines whether the HTU-C will automatically loop
alive back toward the network when it receives LOS or AIS
from the
HTU-R. Options: YES, NO.
Programmable Options: YES, NO.
loopback mode,
HTU-C
61221002L1-5F