Log In To The Configuration Gui - CyberData 011280C Operation Manual

2.5.3 Log in to the Configuration GUI

1. Open your browser to the InformaCast Enabled Paging Adapter IP address.
Note
Note
Note
Note
2. When prompted, use the following default Username and Password to open the configuration
Change the To change the default Web access Username and Password:
Default Username
and Password
1. Enter the new Username from four to 25 alphanumeric characters in the Change Username
2. Enter the new Password from four to 25 alphanumeric characters in the Change Password
3. Enter the new password again in the Re-enter New Password field.
Operations Guide
If the network does not have access to a DHCP server, the device will default to an IP
address of 10.10.10.10.
Make sure that the PC is on the same IP network as the InformaCast Enabled Paging
Adapter.
You may also download CyberData's VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products. 

CyberData's VoIP Discovery Utility program is available at the following website address:
https://www.cyberdata.net/pages/discovery
The unit ships in DHCP mode. To get to the Home page, use the discovery utility to scan for
the device on the network and open your browser from there.
To work with the InformaCast Enabled Paging Adapter configuration after the initial
configuration, log in using the IP address you assign to the device.
the Network Parameters"
Home page:
Username: admin
Password: admin
field. The Username is case-sensitive.
field. The Password is case-sensitive.
Click Save Settings.
Installing the InformaCast Enabled Paging Adapter
provides instructions for entering the IP address.
931767B
Restore the Factory Default Settings
Section 2.5.5, "Configure
CyberData Corporation
18