Log In To The Configuration Gui - CyberData 11233 Operation Manual

2.4.3 Log in to the Configuration GUI

1. Open your browser to the SIP Paging Adapter IP address.
Note
Note
Note
Note
2. When prompted, use the following default Username and Password to open the configuration
Change the
To change the default Web access Username and Password:
Default Username
and Password 1. Enter the new Username from four to 25 alphanumeric characters in the Change Username
2. Enter the new Password from four to 20 alphanumeric characters in the Change Password
3. Enter the new password again in the Re-enter New Password field.
CyberData Corporation
If the network does not have access to a DHCP server, the device will default to an IP
address of 10.10.10.10.
Make sure that the PC is on the same IP network as the SIP Paging Adapter.
You may also download CyberData's VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products. 

CyberData's VoIP Discovery Utility program is available at the following website address:
http://www.cyberdata.net/support/voip/discovery_utility.html
The unit ships in DHCP mode. To get to the Home page, use the discovery utility to scan for
the device on the network and open your browser from there.
To work with the SIP Paging Adapter configuration after the initial configuration, log in using
the IP address you assign to the device.
provides instructions for entering the IP address.
Home page:
Username: admin
Password: admin
field. The Username is case-sensitive.
field. The Password is case-sensitive.
Click Save Settings.
Section 2.4.5, "Configure the Network Parameters"
930622F
Setting Up the SIP Paging Adapter
Log in to the Configuration GUI
Operations Guide
16