CyberData 011280C Operation Manual page 41

2.5.6.1 Point-to-Point Configuration
When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the SIP page
2. Type the IP address of the remote device that you want to contact into the Dial out Extension
Note
Device is set to NOT register with a SIP server
Operations Guide
(Figure 2-16), make sure that the Register with a SIP Server parameter is not
selected.
field
Establishing point-to-point SIP calls may not work with all phones.
Figure 2-16. SIP Page Set to Point-to-Point Mode
Installing the InformaCast Enabled Paging Adapter
931767B
Restore the Factory Default Settings
CyberData Corporation
34