CyberData 011280C Operation Manual page 36

On the SIP page, enter values for the parameters indicated in
Note
Web Page Item
SIP Settings
Enable SIP Operation
SIP Transport Protocol
TLS Version
Verify Server Certificate
Register with a SIP Server
Get SIP Params from InformaCast
Use Cisco SRST
Primary SIP Server
Primary SIP User ID
Primary SIP Auth ID
Primary SIP Auth Password
Backup SIP Server 1
Backup SIP User ID 1
Backup SIP Auth ID 1
Backup SIP Auth Password 1
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-8. SIP Configuration Parameters
Description
When enabled, the device will transmit, receive, and process SIP messages
according to the configured SIP settings below.
Choose the transport protocol for SIP signaling. This will affect all extensions,
including the Nightringer. Default is UDP.
Choose the TLS version for SIP over TLS. Modern security standards strongly
recommend using TLS 1.2.
When enabled, the device will verify the authenticity of the server during the TLS
handshake by its certificate and common name. The TLS handshake will be aborted
if the server is deemed to be inauthentic and SIP registration will not proceed.
When enabled, the device will attempt to register to the configured SIP Server(s) on
this page. To configure the device to send and receive point-to-point SIP calls, enable
SIP Operation and disable Register with a SIP Server (see
"Configure the Fault Detection
When enabled, the device will get its SIP configuration parameters from the
InformaCast server. This will override the manually entered/auto provisioned SIP
configuration.
When enabled, the backup servers are handled according to Cisco SRST
(Survivable Remote Site Telephony). It is required for use in clustered Cisco Unified
Communications Manager topologies.
Enter the SIP server address as an IPv4 address in dotted decimal notation or a fully
qualified domain name. This parameter also becomes the host portion of the SIP-
URI for the device's extension on the primary SIP server. This field can accept
entries of up to 255 characters in length.
Specify the SIP User ID for the Primary SIP Server. This parameter becomes the
user portion of the SIP-URI for the device's extension on the primary SIP server.
Enter up to 64 alphanumeric characters.
Specify the Authenticate ID for the Primary SIP Server. This parameter is required for
SIP registration authentication. Enter up to 64 alphanumeric characters.
Specify the Authenticate Password for the Primary SIP Server. This parameter is
required for SIP registration authentication. Enter up to 64 alphanumeric characters.
Enter the backup SIP server address as an IPv4 address in dotted decimal notation
or a fully qualified domain name. This parameter also becomes the host portion of
the SIP-URI for the device's extension on the backup SIP server. This field can
accept entries of up to 255 characters in length.
Specify the SIP User ID for the first backup SIP Server. This parameter becomes the
user portion of the SIP-URI for the device's extension on the first backup SIP server.
Enter up to 64 alphanumeric characters.
Specify the Authenticate ID for the first backup SIP server. This parameter is required
for SIP registration authentication. Enter up to 64 alphanumeric characters.
Specify the Authenticate Password for the first backup SIP server. This parameter is
required for SIP registration authentication. Enter up to 64 alphanumeric characters.
931767B
Installing the InformaCast Enabled Paging Adapter
) in the following table shows which web page items will be defined
.
Parameters").
Restore the Factory Default Settings
Table 2-8.
Section 2.5.9,
CyberData Corporation
29