Dust Collection - Grizzly G0967 Owner's Manual

17. Position exposed adhesive on upper half of
steel disc that extends above table. Once it
is positioned evenly across disc, press adhe-
sive onto surface.
18. Rotate disc so lower half is above table. Peel
off other half of protective paper, and press
remaining sanding disc against steel disc so
adhesion is complete.
19. Adjust table so there is a
disc and edge of table along its full width (see
Figure 16).
⁄ "
1
16
Sanding Disc
Table
Figure 16. Example of correctly adjusted table.
20. Tighten table cap screws.
21. Spin disc by hand to check if sanding disc
touches table.
— If sanding disc touches table at any point,
loosen table cap screws, then repeat
Steps 19–21 until it does not.
IMPORTANT: DO NOT proceed to Test Run
until you have verified that sanding disc does
not touch table at any point in its rotation.
22. Install disc guard, ensuring guard does not
contact sanding disc.
-18-
⁄ " gap between
1
16
(Top View)

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect dust collection system to machine:
1.
Fit 4" dust hose over dust port, as shown in
Figure 17, and secure in place with hose
clamp.
Figure 17. Example of dust hose attached to
dust port.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Model G0967 (Mfd. Since 06/23)