Dust Collection - Grizzly G0458ZX Owner's Manual

22. Slide table elevation handwheel over shaft
pin (see Figure 15) and secure with 5mm flat
washer and M6-1 x 35 cap screw.
Shaft Pin
Figure 15. Installing table elevation handwheel.
23. Rotate handwheel counterclockwise to lower
table, and remove shipping block shown in
Figure 16.
Figure 16. Location of shipping block.
-18-
Slots
Shipping Block

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect machine to a dust collector:
Fit 4" dust hose over dust port, as shown in
1.
Figure 17, and secure in place with a hose
clamp.
Clamp
Figure 17. Dust hose and clamp installed.
Tug the hose to make sure it does not come
2.
off.
Note: A tight fit is necessary for proper per-
formance.
Model G0458ZX (Mfd. Since 04/24)
Dust Port