Dust Collection - Grizzly T33256 Owner's Manual

3. Install disc cover with screws removed in
Step 1.
4. Attach table to disc guard with (2) M5-.8 x 14
wing knobs (see Figure 12).
5.
Thread M6-1 x 15 handle through 6mm flat
washer and into disc guard (see Figure 12).
x 2
Figure 12. Table attached to disc guard.
6. Refer to Calibrating Table Tilt on Page 38 to
square table to sanding disc.
7.
Attach work stop to platen with (2) M6-1 x 16
cap screws, 6mm lock washers, and 6mm flat
washers (see Figure 13).
Platen
x 2
Figure 13. Work stop attached to platen.
To reduce risk of fingers or workpiece
getting trapped between work stop and
sanding belt, adjust work stop within
sanding belt.
-16-
Disc Guard
Table
Work Stop
⁄ " of
1
16

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Minimum CFM at Dust Port: 100 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect dust collection system to machine:
1.
Fit 2" dust hose over dust port, as shown in
Figure 14, and secure in place with hose
clamp.
Figure 14. Dust hose attached to dust port.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Model T33256 (Mfd. Since 04/22)