I2C Interfaces - Quectel SC600Y-EM Series Hardware Design

DCAM_RST
3)
DCAM_PWDN
SD_DET
FP_SPI_CLK
FP_SPI_CS
FP_SPI_MOSI
FP_SPI_MISO
USB_SS_SEL
NOTES
1. 1) B: Bidirectional digital with CMOS input; PD: nppukp = default pulldown with programmable options
following the colon (:).
2. 2) Wakeup: interrupt pins that can wake up the system.
3. 3) SCAM_PWDN and DCAM_PWDN cannot be pulled up when the module starts up.
4. More details about GPIO configuration, please refer to document [2].

3.14. I2C Interfaces

SC600Y&SC600T provide five I2C interfaces. As an open drain output, each I2C interface should be
pulled up to 1.8V voltage. The SENSOR_I2C interface supports only sensors of the aDSP architecture.
CAM/DCAM_I2C bus is controlled by Linux Kernel code and supports connection to video output related
devices.
Table 17: Pin Definition of I2C Interfaces
Pin Name
TP0_I2C_SCL
TP0_I2C_SDA
TP1_I2C_SCL
TP1_I2C_SDA
SC600Y&SC600T_Hardware_Design
180 GPIO_131
181 GPIO_132
64 GPIO_133
250 GPIO_135
203 GPIO_136
249 GPIO_137
251 GPIO_138
226 GPIO_139
Pin No I/O
140 OD
206 OD
205 OD
204 OD
SC600Y&SC600T Hardware Design
B-PD:nppukp
B-PD:nppukp
B-PD:nppukp
B-PD:nppukp
B-PD:nppukp
B-PD:nppukp
B-PD:nppukp
B-PD:nppukp
Description
I2C clock signal of touch panel
I2C data signal of touch panel
I2C clock signal of touch panel
I2C data signal of touch panel
Smart LTE Module Series
Wakeup
Wakeup
Wakeup
Wakeup
Wakeup
Wakeup
Comment
Used for TP0
Used for TP1
63 / 128