Quectel SC600Y-EM Series Hardware Design page 22

Video Codec
Audio Interfaces
Audio Codec
USB Interface
UART Interfaces
Vibrator drive interface
SD Card Interface
(U)SIM Interfaces
I2C Interfaces
I2S Interface
Flashlight Interface
ADC Interfaces
SPI Interfaces
SC600Y&SC600T_Hardware_Design
SC600Y-XX
Video encoding and decoding: up to 1080P @60fps
Wi-Fi Video: encoding up to 1080P @30fps; decoding up to 1080P @60fps
SC600T-XX
Video encoding and decoding: up to 4K @30fps, up to 1080P @60fps
Wi-Fi Video: encoding up to 1080P @30fps; decoding up to 1080P @60fps
Audio Input
Three analog microphone inputs, integrating internal bias voltage
Audio Output
Class AB stereo headphone output
Class AB earpiece differential output
Class D speaker differential amplifier output
G711, QCELP, EVRC, EVRC-B, EVRC-WB, AMR-NB, AMR-WB, GSM-EFR,
GSM-FR, GSM-HR
Support with USB 3.0 or 2.0 specifications, with transmission rates up to
5Gbps on USB 3.0 and 480Mbps on USB 2.0.
Support USB OTG
Used for AT command communication, data transmission, software debugging
and firmware upgrade
4 UART Interfaces: UART5, UART6, UART4 and UART2
⚫ UART5 & UART6: 4-wire UART interface with RTS/CTS hardware flow
control, baud rate up to 4Mbps
⚫ UART4: 2-wire UART interface
⚫ UART2: 2-wire UART interface used for debugging
Drive ERM vibrator
Support SD 3.0
Support SD card hot-plug
2 (U)SIM interfaces
Support USIM/SIM card: 1.8V/2.95V
Support Dual SIM Dual Standby (supported by default)
Five I2C interfaces, used for peripherals such as TP, camera, sensor, etc.
Support for I2S peripherals
2 high current Flash and torch LED driver
⚫ 1A each for Flash mode and 300mA each for torch mode by default
⚫ 1.5A each for Flash mode and 300mA each for torch mode maximally
2 general purpose ADC interfaces
Support up to 15-bit sampling accuracy
Two SPI interfaces, only support master mode
⚫ One SPI interface used for peripheral device
⚫ One SPI interface used for sensor application, such as fingerprint sensors
Smart LTE Module Series
SC600Y&SC600T Hardware Design
21 / 128