Terex Genie S-80 J Operator's Manual page 61

First Edition • First Printing
Panel Cradle Assembly
1 Apply the warning decal to the front of each
panel cradle (if needed).
2 Install rubber bumper 1 in the panel cradle
base. See the illustration.
3 Secure the bumper with 2 high profile lock
nuts and 2 washers.
Panel Cradle Installation
1 Insert the hook piece through the slots in the
panel cradle base.
2 Hook the panel cradle to the bottom platform
tube in the desired location.
3 Install rubber bumper 2 through the panel
cradle base and the hook piece. See the
illustration.
4 Secure with 2 low profile lock nuts.
Part No. 1306265GT
Operating Instructions
5 If the panel cradle is installed at a platform
floor support tube, insert the U-bolt through the
floor, around the tube and into the panel cradle
base.
6 Secure the U-bolt with 2 nuts and 2 washers.
Proceed to step 9.
7 If the panel cradle is not installed at a platform
floor support tube, use the aluminum tube
provided.
8 Place the tube between the panel cradle and
the platform floor. Insert the U-bolt through the
floor, around the tube and into the panel cradle
base.
9 Repeat above for the second set of parts.
-80 J • S ™
® ®
S -80 J TraX
Operator's Manual
59