Terex Genie S-80 J Operator's Manual page 20

Operator's Manual
Work Area Safety
Do not depend on the tilt alarm as a level indicator.
The tilt alarm sounds in the platform only when the
machine is on a severe slope.
If the tilt alarm sounds when the platform is raised,
use extreme caution. The machine not level
indicator light will come on and the drive function
in one or both directions will not operate. Identify
the condition of the boom on the slope as shown
below. Follow the steps to lower the boom before
moving to a firm, level surface. Do not rotate the
boom while lowering.
The recovery mode should be used only by trained
and authorized personnel.
18
Do not raise or extend the
boom unless the machine
is on a firm, level surface.
-80 J • S
®
S
If the tilt alarm sounds with the
platform uphill:
1
2
If the tilt alarm sounds with the
platform downhill:
1
2
Do not operate the machine in strong or gusty
winds. Do not increase the surface area of the
platform or the load. Increasing the area exposed
to the wind will decrease machine stability.
™
®
-80 J TraX
First Edition • First Printing
Lower the boom.
Retract the boom.
Retract the boom.
Lower the boom.
Do not raise the boom
when wind speeds may
exceed 28 mph/12.5 m/s.
If wind speeds exceed
28 mph/12.5 m/s when the
boom is raised, lower the
boom and do not continue
to operate the machine.
Part No. 1306265GT