Terex Genie S-80 J Operator's Manual page 56

Operator's Manual
Operating Instructions
Rotating turntable on slope
Turntable rotate functions can be disabled when
machine is on a slope greater than 10 degrees.
Return the machine to level ground to restore
turntable rotate function.
Drive Enable
Light flashing indicates that the
boom has moved just past
either non-steer wheel and the
drive function has been
interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off
center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on
the platform controls and the drive chassis to
identify the direction the machine will travel.
Drive Speed Select

Machine on incline symbol: Low range
operation for inclines or rough terrain

Machine on level surface symbol: High range
operation for maximum drive speed
54
Engine RPM Select
Select engine RPM using the symbols on the
control panel.
When the foot switch is not pressed, the engine
will idle at the lowest rpm.

Turtle symbol: Foot switch
activated low speed

Rabbit symbol: Foot switch
activated high speed
Note: If rabbit symbol is selected, high RPM will
not activate for platform functions.
Generator (if equipped)
To operate the generator, move the generator
toggle switch to the on position.
Note: The generator indicator light will turn on.
The generator will turn on and the engine will
continue to run in high RPM mode.
Plug a power tool into AC power outlet located at
the platform, or turntable.
To stop the generator, move the generator toggle
switch to the off position.
Note: The generator indicator light will turn off and
the RPM will return to normal.
-80 J • S ™
® ®
S -80 J TraX
First Edition • First Printing
Part No. 1306265GT