Terex Genie S-80 J Operator's Manual page 44
Hide thumbs
Also See for Genie S-80 J:
- Service and repair manual (135 pages) ,
- Operator's manual supplement (17 pages)
Table of Contents
Advertisement
Operator's Manual
Inspections
Test Drive Tilt Cutout
46 Press down the foot switch.
47 With the boom fully stowed, drive the machine
onto a slope where the machine pitch angle is
greater than 4.5° (front to back).
Result: The machine should continue to drive.
48 Return the machine to level ground and
extend the boom approximately
18 inches/46 cm.
49 Drive the machine onto a slope where the
pitch angle is greater than 4.5° (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
50 Retract the boom to the stowed position.
Result: The machine should drive.
51 Return to level ground and raise the boom to
approximately 4.5° above horizontal.
52 Drive the machine onto a slope where the
pitch angle is greater than 4.5° (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
53 While on the slope, attempt to raise and
extend the boom.
Result: The boom raise and extend functions
should not operate.
54 Lower the boom to the stowed position.
Result: The machine should drive.
55 Return to level ground and stow the boom.
42
56 Press down the foot switch.
57 With the boom fully stowed, drive the machine
onto a slope where the roll angle is greater
than 4.5° (side to side).
Result: The machine should continue to drive.
58 Return the machine to level ground and
extend the boom approximately
18 inches/46 cm.
59 Drive the machine onto a slope where the roll
angle is greater than 4.5° (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
60 Retract the boom to the stowed position.
Result: The machine should drive.
61 Return to level ground and raise the boom to
approximately 4.5° above horizontal.
62 Drive the machine onto a slope where the roll
angle is greater than 4.5° (side to side).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
63 While on the slope, attempt to raise and
extend the boom.
Result: The boom raise and extend functions
should not operate.
64 Lower the boom to the stowed position.
Result: The machine should drive.
65 Return to level ground and stow the boom.
-80 J • S
™
®
®
S
-80 J TraX
First Edition • First Printing
Part No. 1306265GT
Advertisement
Table of Contents
