Terex Genie S-80 J Operator's Manual page 34

Operator's Manual
Controls
Platform Control Panel
1 Horn button
Press this button and the horn will sound.
Release the button and the horn will stop.
2 Platform level switch
Move the platform level
switch up and the level of the
platform will raise. Move the
platform level switch down
and the level of the platform
will lower.
3 Platform rotate switch
Move the platform rotate
switch to the left and the
platform will rotate left.
Move the platform rotate
switch to the right and the
platform will rotate right.
4 Jib boom up/down switch
Move the jib boom switch
up and the jib boom will
raise. Move the jib boom
switch down and the jib
boom will lower.
5 Glow plug indicator light
Light on indicates the glow plugs are on.
32
6 Fault indicator light
Light on indicates a system fault.
7 Platform overload indicator light
Light flashing indicates the platform is
overloaded. The engine will stop and no
functions will operate. Remove weight until the
light goes off and then restart the engine.
8 Machine on incline indicator light
Light on indicates the tilt sensor activation
settings have been exceeded. See the
instructions in the Operating Instructions
section.
9 Generator indicator light
Light on indicates the generator is in use.
10 Generator switch (if equipped)
Move the generator switch up to activate the
generator. Move the switch down to turn off
the generator.
11 Aircraft protection override switch (if equipped)
Move and hold the aircraft protection override
switch to operate the machine when the
platform bumper is against an object.
12 Red Emergency Stop button
Push in the red Emergency Stop button to the
off position to stop all functions and turn the
engine off. Pull out the red Emergency Stop
button to the on position to operate the
machine.
-80 J • S ™
® ®
S -80 J TraX
First Edition • First Printing
Part No. 1306265GT