Terex Genie S-80 J Operator's Manual page 43

First Edition • First Printing
Test the Drive Enable System
36 Press down the foot switch and lower the
boom to the stowed position.
37 Rotate the turntable until the boom moves past
one of the non-steer wheels, or non-steer
tracks.
Result: The drive enable
indicator light should flash
while the boom is anywhere
in the range shown.
38 Move the drive control handle off center.
Result: The drive function should not operate.
39 Move and hold the drive enable toggle switch
to either side and slowly move the drive
control handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that
the drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform controls
and the drive chassis to identify
the direction of travel.
Part No. 1306265GT
Test Limited Drive Speed
40 Press down the foot switch.
41 Raise the boom approximately 5° above
horizontal.
42 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the boom extended should not exceed
1 ft/30 cm per second.
43 Lower the boom to the stowed position.
44 Extend the boom 18 inches/46 cm.
45 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the boom extended should not exceed
1 ft/30 cm per second.
If the drive speed with the boom raised or
extended exceeds 1 ft/30 cm per second,
immediately tag and remove the machine from
service.
-80 J • S ™
® ®
S -80 J TraX
Operator's Manual
Inspections
41