AS MOTOR AS 940 Sherpa 4WD RC Operator's Manual page 52

Possible faults
Display Designation
C1 Microswitch transport posi-
tion does not switch
C2 Blade switches off after 5
seconds.
F1 Drive lever does not work
(RC)
F2 Drive lever does not move
to middle position (RC)
F3 Angle sensor driving
F4 Steering does not work
(RC)
F5 Angle sensor steering
F6 Blade is not properly en-
gaged or disengaged
F7 Blade status unclear
F8 Engine status unclear
F9 Microschalter
Höchste Schnitthöhe schal-
tet nicht
FU Interruption of radio trans-
mission
52
Reasons
Fuse no. 5 (10 A) has blown.
Fuses nos. 1-3 (10 A) have blown.
Cutting height adjustment is blocked.
No activation of a control function in the
RC mode.
Drive lever / rods blocked.
Selection lever operating mode is not
completely set to RC.
Fuses nos. 1-3 (10 A) have blown.
Drive lever / rods blocked.
Fuses nos. 1-3 (10 A) have blown.
Selection lever operating mode is not
completely set to RC.
Fuses nos. 1-3 (10 A) have blown.
Steering is blocked by the ground.
Steering / rods blocked.
Fuses nos. 1-3 (10 A) have blown.
Selection lever operating mode is not
completely set to RC.
Fuses nos. 1-3 (10 A) have blown.
Fuse no. 5 (10 A) has blown.
Fuses nos. 1-3 (10 A) have blown.
Fuse no. 5 (10 A) has blown.
Fuses nos. 1-3 (10 A) have blown.
Engine status unclear, device is not safe
for operation.
Fuse no. 5 (10 A) has blown.
Fuses nos. 1-3 (10 A) have blown.
Cutting height adjustment is blocked.
Battery on the Remote Control Transmit-
ter is empty.
Battery on the device is empty.
Radio range exceeded.
Remedy
Eliminate cause of fuse trigger and replace
fuse.
Eliminate cause of fuse trigger and replace
fuse.
Remove blockage.
Engaging blade.
Remove blockage.
Flip the selection lever of the operating mode
all the way.
Eliminate cause of fuse trigger and replace
fuse.
Remove blockage.
Eliminate cause of fuse trigger and replace
fuse.
Flip the selection lever of the operating mode
all the way.
Eliminate cause of fuse trigger and replace
fuse.
Steer in accordance with the ground proper-
ties.
Remove blockage.
Eliminate cause of fuse trigger and replace
fuse.
Flip the selection lever of the operating mode
all the way.
Eliminate cause of fuse trigger and replace
fuse.
Eliminate cause of fuse trigger and replace
fuse.
Eliminate cause of fuse trigger and replace
fuse.
Eliminate cause of fuse trigger and replace
fuse.
Eliminate cause of fuse trigger and replace
fuse.
Autorisierte Fachwerkstatt.
Eliminate cause of fuse trigger and replace
fuse.
Eliminate cause of fuse trigger and replace
fuse.
Remove blockage.
Replace battery.
Charge the battery (see Checking the bat-
tery) or have authorized service center do so.
Reduce distance between Remote Control
Transmitter and receiver.