Moving Blade To Transport Position; Actuating The Differential Lock In The Rc Mode; Switching Off And Parking In The Rc Mode - AS MOTOR AS 940 Sherpa 4WD RC Operator's Manual

Working in the RC mode
Fig. 29:
Blade On Engaging blade:
Set toggle switch (7) to "On".
Disengaging the blade:
Set toggle switch (7) to "Off".
Off
Notice: For safety reasons, the blade is never engaged au-
tomatically. If, prior to engaging the blade, the toggle switch
"Blade clutch" is set to "On", the toggle switch must be set
to "Off" first.
Notice: For safety reasons, the blade is switched off after
5 seconds if none of the following control elements is acti-
vated:
– Joystick drive
– Joystick steering
– Toggle switch cutting height
– Kippschalter Differentialsperre
Engaging blade:
1. For mowing, set the accelerator lever to the maximum
speed.
2. Leave the danger zone.
3. Set the highest cutting height.
4. Set the toggle switch "Blade clutch" (7) to "On".
ð The blade is engaged.
ð Status indicator on the device flashes.
ð The status indicator on the Remote Control Transmit-
ter (14) flashes.
5. Set the desired cutting height.
When crossing over paths, disengage the blade.
1. Set the toggle switch "Blade clutch" (7) to "Off".
ð The blade is disengaged.
ð The status indicators do not flash any longer.

Moving blade to transport position

The blade can be moved to transport position out of any posi-
tion.
34
14
7
Fig. 30:
Move blade to transport position:
Transp. Pos.
Press button (9).
1. Briefly press the button (9)to move the blade to transport
position.
ð The blade is immediately disengaged.
ð The blade is moved to transport position.
Actuating the differential lock in the RC
mode
6
Fig. 31:
Switch on differential lock:
Diff. Lock On
Set toggle switch (6) to "On".
Switch off differential lock:
1)Set toggle switch 2)(64)) to "Off".
Off
To avoid excessive wear,
– activate the differential lock only when the device is
stopped, if possible.
– release the differential lock when it is no longer absolutely
needed.

Switching off and parking in the RC mode

Warning
Fire hazard
Parts of the device can become extremely hot during oper-
ation and may cause fire.
► Please observe the safety instructions regarding the fire
risk.
9