Switching On Receiver And Remote Control Transmitter; Selecting Radio Frequency; Working In The Mc Mode; Starting The Engine In The Mc Mode - AS MOTOR AS 940 Sherpa 4WD RC Operator's Manual

Switching on receiver and Remote Control Transmitter

Switching on receiver and Remote
Control Transmitter
you must switch on the receiver first, no matter in which oper-
ating mode you want to work.
1. Switch on the main switch on the device.
ð When the control has booted, the status indicators on
the device light up.
15 4
Fig. 17:
2. Insert the key (A) into the start-stop switch (B).
3. Turn the key (A) clockwise to switch on the Remote Con-
trol Transmitter.
4. Wait until the horn of the device sounds once.
ð In the display (15) the frequency number is briefly
shown.
ð The status indicators on the device and on the Re-
mote Control Transmitter (14) go out.
5. Press the button "Horn" (4) on the Remote Control Trans-
mitter to get the device ready for operation.
ð The horn signals thon the device is ready for operation.

Selecting radio frequency

When you switch on the Remote Control Transmitter, the re-
ceiver automatically searches for a suitable frequency.
If several remote controlled devices are operated at the same
time or when another Remote Control Transmitter is located
close by, faults in the radio contact can occur. If this is the
case, change the frequency.
28
14
1
A
B
Changing the radio frequency
15 4
Fig. 18:
1. Continue to press the button "Horn/acknowledge" (4).
2. Press the button "Display frequency" (10).
ð In the display (15) the frequency number is briefly shown.
ð When the Remote Control Transmitter has set a new fre-
quency, the horns sounds and the device is ready for op-
eration.

Working in the MC mode

Requirements
– The selection lever of the operating mode is set to MC
mode.
– The Remote Control Transmitter is in the Remote Control
Transmitter holder.
– There is a driver in the driver's seat.

Starting the engine in the MC mode

Requirements
– The fuel valve is open.
– The drive lever of the device is not in neutral position.
– Receiver and Remote Control Transmitter are switched on
and ready for operation.
Starting
13
5
Fig. 19:
1. When engine is warm:
Move the accelerator lever to middle position (full throttle).
When the engine and outside temperatures are cold
(cold start):
Move the accelerator lever to cold start position (Choke).
2. Press the button "Engine start" (5) on the Remote Control
Transmitter.
10