Nach Dem Arbeiten; Vorsicht Bei Wartung Und Reparatur - AS MOTOR AS 940 Sherpa 4WD RC Operator's Manual

Safety instructions

Nach dem Arbeiten

After mowing, always close the fuel valve.
Before you leave the device, wait until the engine stops com-
pletely. Press the start-stop switch on the Remote Control
Remote Control Transmitter and remove the key. Then
switch off the main switch.
After switching it off, let the device cool down for at least 20
minutes before you store it in a dry, closed, sufficiently venti-
lated room.
Never store the device when there is fuel in the tank inside a
building or where fuel vapors might come into contact with
open fire or sparks.

Vorsicht bei Wartung und Reparatur

Only carry out work as described in these operator's manual.
Have an authorized service center perform all other work.
Only use the blades and spare parts authorized by "AS-Motor
Germany". Unauthorized blades and spare parts can cause
severe injuries.
Before starting any maintenance work, wait until the engine
stops completely. Press the start-stop switch on the Remote
Control Transmitter and remove the key. Then switch off the
main switch.
We would like to explicitly point out that we cannot be held
responsible for damages caused by our devices if
– worn or damages parts were not repaired on time.
– caused by improper repair.
– in case of a part replacement, other parts than our original
components or components approved by us have been
used.
– repair has not been carried out by an authorized service
center.
The same applies to spare parts.
16