Driving In The Rc Mode; Setting The Cutting Height; Engaging The Blade In The Rc Mode - AS MOTOR AS 940 Sherpa 4WD RC Operator's Manual

Driving in the RC mode

Warning
Risk of injury during driving forward and in reverse.
► Make sure no other persons stand in front of or behind
the device and that your path is clear of obstacles.
► Make sure that no other persons, children or animals
are transported.
► Do not ride on the device yourself.
► Make sure that you are outside the danger zone.
Warning
Driving on slopes is dangerous. There is a tilting and slip-
ping hazard.
► Observe the safety instructions regarding driving on
slopes.
► Observe the information in chapter Operating modes.
2
Fig. 27:
Adjust the speed and the direction of travel with the left joy-
stick (2).
The more you push the joystick, the faster the device moves.
Drive forward:
Press joystick forward
Stop (neutral position/parking brake):
Release joystick
Reverse:
Push joystick back
Always reverse slowly. Be especially cautious when the
blade is engaged.
Limiting the speed
Max. Driving Speed
Slow
maximum speed
Turn rotary knob to the left
(direction turtle).
Limit the driving speed with the rotary knob (12) to a speed at
which you can control the device reliably. The maximum
speed is reached when you push the joystick all the way.
12
Fast
maximum speed
Turn rotary knob to the right
(direction rabbit).

Setting the cutting height

Fig. 28:
Continuously adjust the cutting height with the toggle
switch (8) from 1 to 5. The current setting is displayed on the
cutting height display on the device.
Cut. Height Higher cutting height:
Up
Continue to press the toggle switch forward
until the desired cutting height is reached.
Lower cutting height:
Continue to press the toggle switch back-
Down
ward until the desired cutting height is
reached.
Highest cutting height:
Tap the toggle switch once briefly out of the
transport position to the rear.

Engaging the blade in the RC mode

Warning
Risk of injury due to rotating blade.
► Make sure that no persons, children, animals or objects
are in the danger area.
► Make sure that you are outside the danger zone.
Warning
Risk of injury caused by ejected objects.
► Never mow when persons, children, pets or objects are
in the danger area.
► Make sure that you are outside the danger zone.
Only engage the blade when it can rotate freely and does not
touch objects or the ground.
Do not engage the blade in uncut grass because when over-
loaded, the blade can be damaged or wear prematurely.
Requirements
– The engine is running.
– The oil control light is off.
– The blade is not in transport position.
Working in the RC mode
8
33