Acoustic Signals; Signals Of The Device; Signals Of The Remote Control Transmitter; Optical Signals - AS MOTOR AS 940 Sherpa 4WD RC Operator's Manual

Acoustic signals

Carrying the Remote Control Transmitter
Attach the belt to the Remote Control Transmitter the way
you like it:
– Waistband
– Carrying strap
Acoustic signals

Signals of the device

– Single honk signal after the Remote Control Transmitter is
switched on: Radio contact between Remote Control
Transmitter and receiver was successfully established.
– Horn sounds at intervals: Receiver is in operation. No radio
contact to Remote Control Transmitter. Warning of battery
consumption.
– Horn sounds at intervals in RC mode: The device is at too
steep an incline.

Signals of the Remote Control Transmitter

– Horn sounds twice when the Remote Control Transmitter is
switched on: Remote Control Transmitter is ready for oper-
ation.
– Horn sounds for a longer interval when the Remote Control
Transmitter is switched off: Remote Control Transmitter is
switched off.

Optical signals

Status indicators on the device

– Continuous light: Receiver is in operation. Receiver w Re-
ceiver waits for radio contact to Remote Control Transmit-
ter to be established.
– Continuous light: An Emergency stop has occurred.
– Flashing: Beware, blade is engaged.

Lights on the Remote Control Transmitter

– Control indicator oil pressure lights up: No oil pressure.
– Status indicator "Engage blade" is flashing: Beware, blade
is engaged.
24

Display on the Remote Control Transmitter

Frequency: After radio contact has been estab-
lished between Remote Control Transmitter and
Receiver, the frequency number is briefly dis-
played.
Remote Control Transmitter in operation: Red
dot jumps as back and forth.
Warning battery capacity: Quick flashing of an
"L". As soon as the display appears, the Remote
Control Transmitter can be operated for another
approx. 30 minutes.
Error code: When the control detects an error, an
error code is displayed. See chapter on Error
codes.
Energy saving mode: If you do not press any
buttons over a longer period of time, the Remote
Control Transmitter switches off automatically.

LED display on the receiver

1
2
3
Fig. 15:
Description LED 1
No supply Off
Supply OK Lights up
and ready to green
receive
Radio signal Lights up
is received green
(not necessar-
ily from the
associated
transmitter)
Connection to Lights up
the associated green
transmitter
correctly es-
tablished
Fault in RF Lights up
channel (for green
existing radio
connection)
Error when Lights up
checking the green
Emergency
stop relay
LED 2 LED 3
Off Off
Weakly Lights up
flashes green green
Flashes or- Lights up
ange for sig- green
nal reception
Flashes or- Flashes green
ange
Flashes or- Flashes red
ange
Flashes or- Slowly flashes
ange red