ABB ECA06 Configuration And Installation page 76

3.6 Setting the Configuration
Table 19
Note: The AddSub block in the ECA06 does not have the input Signal3 or the
parameter Factor3 and hence the function is defined as:
MulDiv
Available in
ECA06 ECA60 ECA600 EMA60
- X X X
The MulDiv function has four analog inputs, Signal1, Signal2, Signal3 and
Signal4, and one analog output, Value. The block holds two parameters; a gain
Factor, and Bias.
Note: If any input is unconnected, it represents the value 1.0.
76
Name
Value
AddSub Outputs.
Value = Factor1 × Signal1 + Factor2 × Signal2 + Bias
Signal1
Signal2
Signal3
Signal4
Value
Outputs
Analog
MulDiv
×
Signal1 Signal2
×
---------------------------------------------- -
Factor
=
×
Signal3 Signal4
Chapter 3: Configuration
Type
Value
Bias
+
493-0736-11 (6-2)