ABB ECA06 Configuration And Installation page 72

3.6 Setting the Configuration
Each block may be given a twenty letter identification name by configuring the
parameter Identity
Digital Input Communications Buffers
Available in
ECA06 ECA60 ECA600 EMA60
4 8 12 4
Remote digital communication is provided by Digital Input Communications
Buffers (DIC). Via communication a master can feed digital values to the
controller. This is done by writing a bit value into the I/O bit area.
Each Digital Communications Buffer represents a I/O bit.
To configure a Digital Communications Buffer for use, set the parameter Mode to
on. To deselect a digital buffer, set the parameter Mode to Off.
Each block may be given a twenty letter identification name by configuring the
parameter Identity.
Each buffer corresponds to one unique I/O bit.
Note. See Appendix E for a full list of I/O bits and their addresses.
Table 12
Table 13
72
Communication
Name
Mode Off, On
Identity User defined text
Digital Input Communications Buffers Parameters.
Name
Status
Digital Input Communications Buffers Outputs.
Digital
Input
Comms
Buffer
Parameters
Setting
Outputs
Digital
Chapter 3: Configuration
Status
Unit
None
None
Type
493-0736-11 (6-2)