ABB ECA06 Configuration And Installation page 67

Chapter 3: Configuration
• Each block may be given a twenty letter identification name by configuring the
Available in
Analog Input Communication Buffers
ECA06 ECA60 ECA600 EMA60
4 8 12 4
Remote analog communication is provided by Analog Input Communications
Buffers (AIC) via a two wire RS485 serial channel using a communication
protocol. Each Analog Communications Buffer can accept one register value and
produces one analog output, Value. Each buffer block also holds two parameters.
Table 6
Table 7
To select an analog input for use, configure the parameter Mode to on. To deselect
an analog input, set the parameter Mode to Off.
Each block may be given a twenty letter identification name by configuring the
parameter Identity.
Each buffer corresponds to one unique register. See Appendix E for a full list of
registers and their addresses.
493-0736-11 (6-2)
parameter Identity.
Communication
Name
Mode
Identity
Analog Input Communications Buffer Parameters.
Name
Value
Analog Input Communications Buffer Outputs.
Analog
Input
Comms
Buffer
Parameters
Setting
Off, On
User defined text
Outputs
Analog
3.6 Setting the Configuration
Value
Unit
None
None
Type
67