ABB ECA06 Configuration And Installation page 71

Chapter 3: Configuration
When an analog user block is activated, it appears in the Operator Option List.
Here the operator can adjust the (output) signal by pressing the UP/DOWN keys.
It is possible to make the Displayed Range differ from the Signal Range by
changing the parameters LoLimit and HiLimit.
The default values of LoLimit (0.0) and HiLimit (100.0) define the default
(displayed) range
LoLimit determines the value displayed for MinValue, and HiLimit determines
the value displayed for MaxValue.
Digital Inputs
Available in
ECA06 ECA60 ECA600 EMA60
1 3 4 2
Digital Input Blocks (DI) can accept one digital input signal and produce one
digital output signal, Status. Each block also holds two parameters.
Table 10
Table 11
To select a digital input for use, set the parameter Mode to the required logic
mode. To deselect a digital input, set the parameter Mode to Off.
493-0736-11 (6-2)
Screw Terminals
Name
Mode Off, PositiveLogic, NegativeLogic
Identity User defined text
Digital Input Block Parameters.
Name
Status
Digital Input Block Outputs.
–100.0 ≤ Displayed Value ≤ 100.0
Digital
Input
Block
Parameters
Setting
Outputs
Digital
3.6 Setting the Configuration
Status
Unit
None
None
Type
71