ABB ECA06 Configuration And Installation page 122

3.6 Setting the Configuration
The following parameters apply to both the Simple Set Point Ramp and the
Advanced Set Point Ramp.
RampMode
Hold
TimeUnit
RampStart
StartValue
Table 85
Ramp Start Condition
The following Control Mode transitions, which represent a change from False to
True on the AutoStatus input, start the Ramp function:
• Manual → Auto
• Forced Output → Auto
• Tracking → Auto
The following Control Mode transitions which represent a change from True to
False on the AutoStatus input, stop the Ramp function:
• Auto → Manual
• Auto → Forced Output
• Auto → Tracking
122
Name
Off, Simple, Advanced
Off, On
Minutes, Seconds
StartFromPV, StartFromStartValue
MinValue ≤ StartValue ≤ MaxValue
Set Point Ramp Parameters.
Parameters
Setting
Chapter 3: Configuration
Unit
None
None
None
None
TimeUnit
493-0736-11 (6-2)