Radiator - Can-Am OUTLANDER 6x6 T 2021 Series Operator's Manual

tmr2011-010-005_a
1. Outlet bore to the engine oil providing
system
2. Inlet bore from the oil pump to the oil filter
2. Install a NEW O-ring on oil filter
cover.
3. Install the new filter into the cover.
4. Apply engine oil on O-ring and on
end of filter.
vmr2006-008-001_a
1. Slightly oil
2. Slightly oil
5. Install the cover on the engine.
NOTICE
Pay attention to avoid
pinching the O-ring during filter and
cover installation.
6. Tighten oil filter cover screws to rec-
ommended specification.
TIGHTENING TORQUE
Oil filter cover
screws
7. Reinstall remaining parts if applica-
ble.
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
8. Wipe off any oil spillage on engine.

4) Radiator

Radiator Inspection
Periodically check the radiator area for
cleanliness.
vmo2012-012-041
TYPICAL - PARTS REMOVED FOR CLARITY
Inspect radiator and hoses for leaks or
any damage.
Inspect radiating fins. They must be
clean, free of mud, dirt, leaves and any
other deposit that would prevent the
radiator to cool properly.
Remove as much deposits as you can
with your hands. If water is available in
proximity, try rinsing the radiating fins.
NOTE: Inner fenders can be removed
to ease cleaning.
If available, use a garden hose to rinse
the radiating fins.
CAUTION Never clean radiator
with your hands when it is hot. Let
the radiator cool down before clean-
ing.
NOTICE
the radiating fins when cleaning. Do
not use any object/tool that could
damage the fins. The fins are pur-
posely thin parts to allow efficient
cooling. WHEN RINSING, USE LOW
PRESSURE ONLY, NEVER USE A
HIGH PRESSURE WASHER.
______________
II MAINTENANCE PROCEDURES
Be careful not to damage
139