Radiator Fans; Clutch Fluid (Sm6 Model) - Can-Am Spyder RT Operator's Manual

Hide thumbs Also See for Spyder RT:
Table of Contents

Advertisement

Radiator Fans

Radiator Fans Cleaning
Remove any debris from the grills.
NOTE: Do not clean with a pressure
washer because it can damage the
radiator fins. Clean only with com-
pressed air from behind (blow the air
from the back towards the front).
rmo2014-005-024_a
1. Radiator fan grills
NOTE: When the engine is running
and the vehicle is stopped or travelling
at low speed, the radiator fans push air
towards the front of the vehicle. When
the vehicle is travelling at higher speed
the fans push the air towards the back
of the vehicle.

Clutch Fluid (SM6 Model)

Clutch Fluid Level Verification
Check the clutch fluid level when the
clutch does not operate normally or
when it is difficult to shift gears with
the gearshift lever.
The clutch fluid reservoir is near the re-
verse button on the left handlebar.
Check the clutch fluid level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Set the handlebar straight in order to
position the top of clutch fluid reser-
voir horizontally.
3. Wipe clean the cap area.
4. Use the Phillips head screwdriver lo-
cated in the toolkit.
5. Unscrew cap retaining screws.
rmo2010-001-005
6. Carefully remove cap. Pay attention
not to drop the cap seal.
7. Look inside the reservoir to see the
fluid level.
Check clutch fluid level inside the
reservoir:
– The fluid must be flush to the fill
level line (protuberance on the
reservoir wall).
rmo2010-001-006_b
FLUID REMOVED FOR CLARITY PURPOSE
1. Fill level line
Adding Clutch Fluid
1. If the fluid level is lower than spec-
ified, add fluid to the reservoir up
to the fill level line. Use only DOT 4
brake fluid.
2. Add fluid as required. Do not over-
fill.
NOTICE
spills.
______________
MAINTENANCE PROCEDURES
Immediately wipe up any
129

Advertisement

Table of Contents
loading

Table of Contents