Shift Lever - Can-Am OUTLANDER 6x6 T 2021 Series Operator's Manual

NOTE: When using the override func-
tion, the gauge will scroll an OVER-
RIDE message to confirm that the
function is activated.
3. To disengage the override function,
simply release the override button.
DPS Function (Models with DPS)
This button is also used to change the
DPS mode.
To change DPS mode, refer to
YOUR RIDE
.
Emergency Throttle Operation in
Limp Home Mode
In case of a throttle lever sensor or
throttle position sensor failure, the
override/DPS button can be used to
increase the engine speed in order to
drive the vehicle at a low speed.
If such a failure occurs, a message will
be displayed on the gauge.
Press the override/DPS button. If the
engine speed rises, drive the vehicle
safely. If not, hold the button and press
the throttle lever.
Headlight Dimmer Switch
Move the switch forward to select the
high beam and rearward to select the
low beam.
219001868_011_f
Turn Signal Switch
Move the switch to the left to activate
LH turn signals and to the right to acti-
vate RH turn signals.
To stop the turn signals, move the
switch back to the middle position.
TUNE
219001868_011_g
Horn Button
Push the button to use the horn. It will
stop when the button is released.
219001868_011_h

7) Shift Lever

The shift lever is located on the RH side
of the console.
sfvmo2014-012-010
SHIFT LEVER LOCATION
The shift lever is used to change the
gearbox position.
_______________
I CONTROLS
91