Gearbox Oil - Can-Am OUTLANDER 6x6 T 2021 Series Operator's Manual

8) Gearbox Oil

Gearbox Oil Level Verification
NOTICE
Check level and refill if
necessary. Do not overfill. Operat-
ing the gearbox with an improper
level may severely damage gear-
box. Wipe off any spillage.
Place the vehicle on a level surface.
Select NEUTRAL position.
Apply brake lock.
Check the gearbox oil level when en-
gine cold, not running, by removing the
gearbox oil level plug.
vmo2012-012-056_a
TYPICAL - 650 ENGINE
1. Drain plug
2. Oil level plug
vmo2012-012-057_a
TYPICAL - 1000 ENGINE
1. Drain plug
2. Oil level plug
The oil should be level with the bottom
of the oil level hole.
Refill as required until gearbox oil level
flows through oil level hole.
Recommended Gearbox Oil
RECOMMENDED GEARBOX OIL
Scandinavia
All other countries
NOTE: The XPS oil is specially formu-
lated to meet the lubrication require-
ments of this gearbox. BRP strongly
recommends the use of its XPS oil.
However, if the XPS synthetic gear oil
is not available, use the following lubri-
cant:
GEARBOX OIL REQUIREMENT
75W 140 API GL-5 synthetic gear oil
NOTICE
of oil when servicing. Do not mix
with other types of oil.
Gearbox Oil Change
NOTE: When replacing the gearbox
oil, it is recommended to clean the ve-
hicle speed sensor (VSS) at the same
time.
Place the vehicle on a level surface.
Clean drain plug area.
Clean the oil level plug area.
Under the vehicle, place a drain pan un-
derneath the oil drain plug area.
Remove the oil level plug.
Remove the gearbox drain plug.
______________
II MAINTENANCE PROCEDURES
75W140
SYNTHETIC
GEAR OIL (EUR)
(P/N 779215)
75W140
SYNTHETIC
GEAR OIL
(P/N 779160)
Do not use another types
145