Radiator - Can-Am 219 002 095 Operator's Manual

Unscrew the oil filter cover.
tmr2011-010-004_a
1. Oil filter screw
2. Oil filter cover
3. O-ring
4. Oil filter
NOTICE
Pay attention to avoid
pinching the O-ring during filter and
cover installation.
Remove the oil filter and replace with a
new filter.
Install a NEW O-ring on oil filter cover.
Install the new filter into the cover.
Apply engine oil on O-ring and on end
of filter.
Screw oil filter cover in place.
Tighten oil filter cover screws to rec-
ommended specification.
TIGHTENING TORQUE
Oil filter cover
screws
Wipe out any oil spillage on engine.

Radiator

Radiator Inspection
Periodically check the radiator area for
cleanliness.
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
______________
MAINTENANCE PROCEDURES
vmo2012-014-018
TYPICAL
Inspect radiator and hoses for leaks or
any damage.
Inspect radiating fins. They must be
clean, free of mud, dirt, leaves and any
other deposit that would prevent the
radiator to cool properly.
Remove as much deposits as you can
with your hands. If water is available in
proximity, try rinsing the radiating fins.
If available, use a garden hose to rinse
the radiating fins.
CAUTION Never clean radiator
with your hands when it is hot. Let
the radiator cool down before clean-
ing.
NOTICE
Be careful not to damage
the radiating fins when cleaning. Do
not use any object/tool that could
damage the fins. The fins are pur-
posely thin parts to allow effici ent
cooling. WHEN RINSING, USE LOW
PRESSURE ONLY, NEVER USE A
HIGH PRESSURE WASHER.
See an authorized Can-Am deal er, re-
pair shop or person of your own choos-
ing to check the performance of the
cooling system.
113