Can-Am OUTLANDER 6x6 T 2021 Series Operator's Manual page 92

I CONTROLS
To stop engine, set the engine stop
switch to the STOP position.
219001868_011_c
Hazard Lights Switch
219001868_011_d
Push the switch down to activate the
hazard lights. Pull it up to turn off.
The hazard lights system operates all
the turn signals simultaneously. Used
when the vehicle is stationary to in-
dicate that the vehicle is temporarily
obstructing traffic.
NOTE: Hazard lights can be activated
even when the vehicle electrical sys-
tem is shut down.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
______________
90
Override/DPS Button
Depending on the vehicle model, this
button can have 3 functions.
219001868_011_e
Override Function
The override switch main function is to
bypass the engine speed limiter in re-
verse operation by allowing maximum
engine torque.
Use the "override" mode only if the
vehicle is caught in mud or other
soft terrain and the "low range" is
not enough. Make sure the area is
secure before using the "override"
mode. Do not use the "override"
mode when driving normally in
reverse, this would result in exces-
sive speed.
To engage the override function, pro-
ceed as follows:
While the shift lever is set to REVERSE
position.
1. Ensure that the vehicle is stopped.
2. Press and hold the override/DPS
button then press the throttle lever
gradually.
WARNING
WARNING