Table of Contents
Advertisement
Safety equipment
5
Remove the knee joint with the attached brake
band from its attachment in the clutch cover.
Cleaning and checking
•
Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
•
Measure the thickness of the chain brake
band. It must not be less than 0.6 mm at any
point. See figure 5.
•
Lubricate the knee joint with grease.
6.2 Assembling the chain brake
1
Place the knee joint with the fitted brake band in
its groove in the clutch cover as outlined in Figure
6. The space for the spring in the cover must be
lubricated with grease.
2
Make sure the brake band is fitted to the hooks in
the clutch cover. See Figure 7.
3
Compress the spring with a wide screwdriver and
press it down with your thumb. See Figure 8.
4
Fit the cover over the brake spring and screw the
screws back in place. See Figure 3 "Dismantling
the chain brake".
14
– English
Fig 5
Fig 6
Fig 7
Fig 8
Advertisement
Chapters
Table of Contents
