Dismantling The Start/Stop Switch; Assembling The Start/Stop Control - Husqvarna T435 Workshop Manual

6.6 Dismantling the start/ stop switch
1
Bend the start/stop switch loose with a screwdriver,
see fi gure 22.
2
Check that the start/stop switch is intact.
Cleaning and checking
Clean and check carefully all components. If there
are cracks or other defects, these details should
be replaced with new ones. Always use original
spare parts.
6.7 Assembling the start/stop switch
1
Attach the cables, see fi gure 23.
2
Push the start/stop switch into the slot.
Attach cables A and B, which come from the ignition
coil on the plates on the stop switch, see fi gure 24.
Fig 22
Fig 23
Fig 24
Safety equipment
21
English –