Operating; Driving From The Machine; Switching On The Machine - SAMES KREMLIN PU 3000 Documentation

6. OPERATING



DRIVING FROM THE MACHINE

SCREEN
Different menus and information relating to the machine are displayed on the alphanumeric screen.
KEYBOARD
ESC
OK
▲
▼
The keyboard is controlled thanks to a magnet provided with the machine. That control mode enables the
user to drive the machine inside the booth if the box is installed behind the booth glass panel. This
technology enables the operator to save time and to carry out his work from the place application.


SWITCHING ON THE MACHINE

The placing of the system into operation requires that the BASE, CATALYST and
SOLVENT drums are full enough to ensure the production.
Connect the gun before placing the system into operation.
Unscrew the 3 air regulators before supplying air to the installation.
Supply air to the PU 3000 (minimum 4 bar / 58 psi).
Switch on the control box (switch located on the side of the box).
When switching on the control box, a menu is displayed on the screen.
Nota : Parameters have been set up in the factory before the delivery of the machine. You must adapt the
parameters to the use. They must be modified by an authorized person (refer to list of parameters).
SAMES KREMLIN
That key enables the user to quit the menus or the different modes (production,
flushing, parameters).
That key enables the user to enter in the different menus or to validate a value of
parameter.
That key enables the user to shift from a menu to another and to increase the value
of a parameter during modifications of value.
That key enables the user to shift from a menu to another and to decrease the value
of a parameter during modifications of value.
Page 17 Manual : 573.199.112