Table of Contents
Advertisement
FLUID SECTION, MODEL F260 (CATALYST) (REFER TO DOC. 573.409.050)
Guards (air motor cover, coupling shields, housings ...) have been designed for
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
1 - FLUID SECTION REPLACEMENT
To remove a component of the pump :
- Disassemble all the accessories of the pump (rods, filter), if it necessary.
- Put aside the pump, if it is necessary (the pump is fitted with an hoisting ring).
The fluid section of the pump consists of 2
sub-assemblies :
- the upper part (bellows suction
sub-assembly : A)
- the lower part (fluid sub-assembly
: B)
This sub-assembly is more frequently
service than the A sub-assembly.
SAMES KREMLIN
safe use of the equipment.
Before removing the B sub-assembly or the A
sub-assembly, you must remove the connecting
rod (41). For that :
- Unscrew the nut fitting (38) and the screws (43 &
45),
- Remove the connecting rod (41).
A
B
Page 73
36
37
38
Manual : 573.199.112
44
45
43
42
41
Advertisement
Table of Contents
