Table of Contents
Advertisement
FLUID SECTION, MODEL C260 (BASE) (REFER TO DOC. 573.414.050)
Guards (air motor cover, coupling shields, housings ...) have been designed for
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
Suction valve (15)
Disassembly
Unscrew the suction valve (16). (If the cylinder (2) remains
attached to the suction valve, unscrew both parts, then hold
cylinder (2) by inserting a rod into the cylinder holes designed for
this purpose).
The ball (17) is secured on the valve (16) by means of a circlips
(18).
Clean the parts with the appropriate cleaning solvent.
Reassembly
Reinstall the ball (17) and the circlips (18) on the valve body (16).
Change the seal (19). Lubricate it.
Lubricate the valve body threading.
Reinstall the valve assembly (15) on the cylinder (2).
Cylinder (2)
In order to make easier the disassembly, a hole is made in the
cylinder (2) at each end.
Depending on the part that it is unscrewed first, insert a rod into
one of these holes to unscrew the other part.
When reassemblying, make sure the two seals (19 and 24) are
installed. Lubricate them.
Lubricate the inside of the cylinder (grease, type A1) and the threadings to prevent from
damaging the mobile packing (grease, type A2) (Refer to greases in the Assembly instructions §).
SAMES KREMLIN
WARNING!
Before any action on the pump, shut off the compressed air supply
and depressurize the systems by triggering the spray gun.
safe use of the equipment.
Page 69
Manual : 573.199.112
Advertisement
Table of Contents
