Table of Contents
Advertisement
When reassembling :
Change the seals (11), lubricate them then install new cartridge (9a / 9b / 9c / 9d) in cylinder
support (2) by pushing it until the cartridge shoulder comes to lean against the cylinder
support shoulder. Then reinstall all the components in the reverse order of disassembly.
Install the valve in front of the module body.
Centre the cartridge (9a / 9b / 9c / 9d) on the module body and reinstall screws (7).
PISTON PACKING (Ind. 14)
Unscrew the cylinder (4).
Remove the spring (5).
Unscrew the opening signal light (8).
Unscrew the nut (16).
Remove the support washer (15) and the packing (14).
Clean the parts and change them if necessary.
Before reassembling :
Before assembling on the piston (13), take care of shaping the cartridge lip (14) by hand as
shown in the above drawing (cartridge turned up on the piston).
The
nut
(eg : Loctite 222).
Index
Instructions
PTFE grease
A 1
Low strength
C 2
- Anaerobic Adhesive
SAMES KREMLIN
8
5
(16)
must
be
glued
4
16
15
on
the
piston
Description
'TECHNILUB' grease
(10 ml / 0.34 oz)
Loctite 222 (50 ml / 1.7 oz)
Page 45
14
13
(13)
with
Manual : 573.199.112
loctite
adhesive
Part number
560.440.101
554.180.010
Advertisement
Table of Contents
