Fast Start Sequence - iBike Gen III Operating Instructions Manual

STEP ONE:
ENTER INFORMATION INTO THE IBIKE
Important information about you and your bike is entered into the iBike with special
screens. Information entry is organized into three "sequences":
1) "Fast Start" sequence: six required setup steps.
2) "User" sequence: eight optional steps that the iBike owner should complete when
possible but which are not required
3) "Racr" (Racer) sequence: six optional, advanced settings of interest primarily to
advanced riders and racers
When a sequence screen is set to YES (for example, "USER YES"), clicking the up arrow
enters the sequence and shows the steps of that sequence. When a sequence screen is set
to NO (for example, "USER NO"), clicking the up arrow bypasses the steps of that
sequence; the steps in the User sequence will be hidden.
To perform a sequence, enter Setup and click the up arrow repeatedly to scroll to the
sequence you want to perform. Then, click the center button. Use the up arrow to select
YES (for example, "RACR YES"). Click the center button. YES stops flashing. Now, click
the up arrow to perform the first step of the selected sequence.
USING THE IBIKE BUTTONS TO PERFORM A SETUP
STEP
To perform a setup step, click the center button. The parameter to be adjusted flashes on
the screen. Use the up, down, left and right arrows as needed to change the parameter.
When the parameter is set to the desired value, click the center button to confirm the
entry. The word "DONE" flashes and the iBike advances to the next step of the sequence.
IMPORTANT: Click the UP arrow to advance sequentially from step 1, to step 2, etc.
7
Copyright Velocomp LLP 2005-2011