Day-To-Day Setup Screens - iBike Gen III Operating Instructions Manual

DAY-TO-DAY SETUP SCREENS

Your iBike setup is designed around one-time setup sequences. Once these sequences are
performed, you'll rarely need to access them to make changes. So, unless you choose to
reveal the sequence steps, they'll remain hidden from view.
Some iBike setup and calibration steps are very common, so much so that you'll want easy
access to them. We've gathered the most common setup items together as "day-to-day"
screens that you'll find whenever you enter setup.
All of the day-to-day setup screens are listed below. Many of them have been described so
we won't repeat their function here. The new screens will be in BOLD:
1) CAL WIND
This important calibration is the screen you'll see when entering Setup. Once you
click the center button to perform the wind calibration, your iBike will automatically
exit setup after a few seconds, OR you can click the up arrow to move to the next
screen:
2) TILT
3) CAL RIDE
4) BATT (battery voltage). Use this screen to find out the voltage of your battery
(3.00V in this image):
IMPORTANT
START OF YOUR RIDE, REPLACE THE BATTERY!
5) ALT (altitude)
Use this screen to enter the starting elevation for your ride.
TIP: THE STARTING ELEVATION IS OPTIONAL AND NOT REQUIRED FOR ANY IBIKE
CALCULATIONS
IMPORTANT: EVEN IF YOUR IBIKE HASN'T MOVED, THE STARTING ELEVATION WILL
CHANGE WHEN WEATHER CONDITIONS CHANGE. THIS IS NORMAL.
6) TOTAL WGHT
: IF YOUR BATTERY VOLTAGE IS 275 OR BELOW AT THE
Copyright Velocomp LLP 2005-2011
41